rfitts46
New User
Feb 17, 2018, 4:20 AM
Post #31 of 55
(5151 views)
Shortcut
|
Re: [jts1957] Sharp Aquous LC46D64U blinking green power light
[In reply to]
|
Can't Post
|
|
The content in Post #16 of this thread I copied from another thread. The link was in the other thread, it showed the pinout of the 4 pin connector on the main board. But to be honest it was taken from the service manual, schematic of main board. What do you mean by use an isolation resistor 1K? Dont use a wire jumper, use a 1K resistor? Insert one lead into pin2 and the other into pin 3....pin 3 would see 3V?
(This post was edited by rfitts46 on Feb 17, 2018, 4:29 AM)
|