Vertical out on zenith


	FORUM HOME	SEARCH POSTS	WHO'S ONLINE	LOG IN	RULES F.A.Q.

TV Forums: TV Equipment: TV Repair Forum:
Vertical out on zenith

Print Thread

BrianD
New User

Apr 11, 2005, 3:57 PM

Post #1 of 3 (1223 views)
Shortcut

Vertical out on zenith	Can't Post

I have a SL2567S with a horizontal line on the screen. I have located the vertical IC and associated components, but don't know where to go from here. If anyone is familiar with these Zeniths, I would really appreciate the help.

mel
Veteran

Apr 11, 2005, 6:18 PM

Post #2 of 3 (1219 views)
Shortcut

Re: [BrianD] Vertical out on zenith [In reply to]	Can't Post

Although I do not have the schematic for that specific model, it apears to be a 94/95 vintage and most of these models were very similar. I have found that many times this is caused by the failure of the fusible resistor in the power supply to the vertical IC. It is probably a 1 ohm resistor identified as RX2342 off of pin 10 of flyback. This usually seems to be just a random failure and replacing it has fixed the problem. Otherwise, you probably need to replace the IC itself. You might also want to check out www.FreeFlatScreens.com/?r=10948674 for an opportunity to earn a free replacement for this set with a little effort on your part.

BrianD
New User

Apr 11, 2005, 6:41 PM

Post #3 of 3 (1218 views)
Shortcut

Re: [mel] Vertical out on zenith [In reply to]	Can't Post

Thank you Mel, it is a 94. I'll look for that fused resistor and let you know if that did the trick!

Print Thread

Search for (options)

- Page loaded in: 0.20 s on (CGI/1.1)